Page 2 of 2

Re: Poor Man's 3D Printer

Posted: Fri Aug 14, 2015 2:09 am
by kyogjj
Step 10: Results
Image
here you can see the first results before/after calibration and some final changes in the firmware, the cube was printed with 1.75mm ABS filament, the edge length in the gcode is 10mm the final result 10.06mm !!!

Re: Poor Man's 3D Printer

Posted: Fri Aug 14, 2015 2:10 am
by kyogjj
Step 11: First Update
I change the driver board to ramps 1.4 with A4988 Stepper driver because they have become very cheap on ebay.

( board + 4 stepper drivers about 20$ incl. shipping)

I have supplied the x/y/z steppers with 8 Volt, 12 Volt is to much for those tiny things, with only 5 Volt the drivers won't work. i also limit the current to 300mA (with the poti at drivers)

Here are my results with using Marlin as Firmware.

I uploaded my configuration file from Marlin and also the slicr settings.

Re: Poor Man's 3D Printer

Posted: Fri Aug 14, 2015 2:25 am
by kyogjj
Step 12: Photos from printing
Image
Image
Image
Image
Image
Image

Re: Poor Man's 3D Printer

Posted: Fri Aug 14, 2015 2:26 am
by kyogjj
Step 13: Update 2
Image
Because of the great demand, I have uploaded a drawing from the ground frame.